Bell EXPRESSVU Technical Information PDF herunterladen (Seite 9)

Using The System

Using The Remote Control

Page 3-9

The following setup is required to use the RECOVER button:

• The remote control must be set up to control the TV and, if installed, the VCR (see

page 3-51).

• If a VCR is installed, make sure it is connected.

• On a remote TV, the RECOVER button must be programmed to tune your remote TV

to the modulator channel,(3 or 4)

To use the RECOVER button, complete the following instructions:

1. Press and hold the RECOVER button until all four mode buttons light, and then let go

of the button. The Sat mode button flashes twice and then all four mode buttons flash

three times.

2. Press the RECOVER button. Wait for the TV or VCR mode button to flash once and

then all four mode buttons to flash once.

3. If you see the System Info screen, press the SELECT button to close the screen. You

have recovered your satellite video.

4. If you do not see the System Info screen, repeat steps 2 and 3 until you have

recovered your satellite video.

Note: Press any remote control button other than the RECOVER button to end this

procedure.

Note: If the RECOVER button is not programmed to a specific channel, the

RECOVER button will first try to tune your TV to channel 3, then channel 4, and then

other video inputs with each press of the RECOVER button. You may need to press

the RECOVER button up to 30 times to recover your satellite TV video. If the

RECOVER button is programmed to a specific channel the recover button will tune

the TV to the specific channel (for example, channel 3).

CHANGING THE REMOTE CONTROL ADDRESS

The remote control and receiver can operate on any one of 16 addresses; however, they

must both be on the same address for the remote to control the receiver. This section

explains how to change the address in both devices.

Note: Do not change the address of the remote unless absolutely necessary because the

remote cannot control the receiver if the two devices have different addresses.

4100_Ch3_eng 6/15/05 8:34 AM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Keine Kommentare

Bell EXPRESSVU Technical Information Seite 9