Bell EXPRESSVU Technical Information PDF herunterladen (Seite 4)

User Guide

Page 3-4

INSTALLING BATTERIES IN REMOTE

The remote control uses 4 AAA batteries. When

you replace old batteries, you should replace all of

the batteries. Use batteries of the same grade and

do not mix batteries of different grades. Alkaline

batteries provide longer battery life.

1. Push down on the slot in the battery case cover

(on the back of the remote control) and slide off

the cover.

2. Insert the new batteries, making sure to match

the plus (+) ends with the plus markings on the

battery case.

3. Replace the battery cover by sliding the cover

back up into place.

USING THE REMOTE

THE REMOTE CONTROL BUTTONS

This section describes the buttons on the remote control. Some features described below

may not be applicable with your particular satellite receiver model.

MODE LIGHTS

The SAT,TV,VCR, and AUX mode buttons indicate which

device the remote will control. To change modes, press the

appropriate MODE button. The corresponding background

light will light for 2 seconds.

SAT MODE BUTTON

Press this button to set the remote to SAT mode, to control the

receiver. The SAT mode button’s back light turns ON to show that the

remote is set to SAT mode.

Make sure to keep the remote in SAT mode to use the buttons that are

described here.

TV/VIDEO BUTTON

If you connect the receiver using only the RF or VHF connections,

use this button, in SAT mode, to switch between the receiver and an

alternate video source such as cable or broadcast TV antenna input

(it will switch to the device routed into the TV Antenna Cable In).

In TV mode, this button will switch between video inputs on some

televisions (check your television owner’s manual for more details).

4100_Ch3_eng 6/15/05 8:34 AM Page 4

1 2 3 4 5 6 7 8 9 ... 55 56

Keine Kommentare

Bell EXPRESSVU Technical Information Seite 4